Fixing the Base Position of the Printing Area

You can use a positioning jig to fix the lower right corner of the table as the base position (home position) of the printing area.

MEMO
The positioning jig has a correct orientation for use. Use the figure below as a reference.
  • The fixing holes are close to one side of the jig, with the wider side facing the outside of the table.
  • Make sure that the top and bottom sides are correct.
  • You can also use multiple positioning jigs according to the size of the object to be printed on.
FixingTool1

You can also use multiple positioning jigs according to the size of the object to be printed on.

FixingTool2
IMPORTANT

When using positioning jigs, select objects to be printed on that have a thickness of 3 mm (0.1 in.) or more. If the object is less than 3 mm (0.1 in.) thick, the print surface will be lower than the positioning jigs, preventing the height from being set correctly.