Cleaning Error

During operation, an error was detected with the internal pressure, and an emergency stop was executed.

Operation cannot be continued. Perform the following operations.
  1. Switch the sub power off and back on.
  2. Perform Manual Cleaning.
  3. Perform Ink Renewal Inside Damper.
  4. To check whether the error has been cleared, perform the same operation that you performed when the error occurred (for example, printing).

    You may also perform a printing test. If no error messages appear when you perform the above operations, the work is complete.

    If Cleaning Error appears again while you perform steps 2 to 4, perform the following operations.

  5. Replace the print head cap.
  6. Perform steps 2 to 4.

    If, once more, an error message appears during this work, switch the sub power off, and then contact your authorized dealer.