2. Clean the print heads.

Procedure
  1. Moisten a new cleaning stick with the cleaning liquid.
    IMPORTANT
    • Be sure to use one of the included cleaning sticks.
    • Do not use a previously used cleaning stick.
    • Do not put a previously used cleaning stick into the cleaning liquid.


  2. Prepare the tray.
    • When Table Position: Center is selected

      Place the tray on the table.

    • When Table Position: Back is selected

      Hold the tray in your hands.

  3. Clean the locations shown in the following figure.
    Be especially careful to clean away any fibrous dust (lint).
    IMPORTANT

    When Table Position: Back is selected, catch the cleaning liquid with a hand-held tray to prevent it from dripping onto the machine.

    SEA_ManualCL
    1. Press the wide surface of the cleaning stick against the left side and wipe it off. Then, press the opposite surface (which is clean) against the right side and wipe it off.


    2. Stand the cleaning stick upright and wipe off all sides.


    3. Use the wide surface of the cleaning stick to wipe away any dirt from the locations shown in the figure.
      If this area has any ink or cleaning liquid that appears likely to drip, use a dry cloth that is not fluffy to gently wipe away the ink or cleaning liquid.


  4. Put away the tray.
  5. Close the front cover.
    MEMO

    Be sure to hold the handle of the front cover and keep holding it until the cover is completely opened or closed.

    If you do not open and close the front cover gently, it may break or you may be injured.

    CoverOpen2
  6. Tap Finish All.

    Cleaning will start. The details of the operation in progress and the (approximate) remaining time of that work are displayed in the status bar at the top of the screen.

    When the work is finished, the status bar returns to its original display.

  7. Tap AP-640_Panel_Icon_HOME to return to the home screen.