Table Height Error

Check the table height. Press [OK].

This message is displayed when the head gap sensor interferes with the object during non-printing operations.

Confirm that the object is not too large to be loaded in the printer. If it is too large, load an object that is the appropriate size.

Tap OK to clear the message.

Operation was stopped because the media height is abnormal. Press [OK].
If the following clearance settings are configured, the table is automatically lowered and printing is stopped when an abnormal object height is detected during printing.
  • Clearance Settings: Stop
Confirm that the object is not too large to be loaded in the printer. If it is too large, load an object that is the appropriate size.

Tap OK to clear the message.

The table height was readjusted. Press [OK].
If the following clearance settings are configured, the table height is automatically readjusted and printing resumes when an abnormal object height is detected during printing. When printing is finished, the user is notified that printed has been performed with the table height readjusted.
  • Clearance Settings: Readjust
  • Warning Display: Enable

When the message The table height was readjusted. appears, tap OK to clear the message.