Insufficient Media Printing Area

The print data is larger than the media width. Continue output?

This message appears when the size of the printing data is larger than the printing area of the loaded object.

To continue performing output without making corrections, tap Continue Output. At this time, the portion extending beyond the printing area is not output.

To cancel output, tap Cancel. Check the data output settings, and then send the data again.

Crop marks cannot be added because the print data is larger than the media width. Continue output?

This message appears when one of the following situations is detected.

  • The size of the data with crop marks is larger than the printing area of the loaded object.
  • The width of the printing data is 60 mm (2.36 in.) or less.
To continue performing output without making corrections, tap Continue Output. The data is output without printing the crop marks.

To cancel output, tap Cancel. Check the data output settings, and then send the data again.

The size of the data being output is too small.

The horizontal-direction (scan-direction) size of the data should be at least 61 mm (2.41 in.). To continue performing output without making corrections, tap Continue Output. At this time, the data is output without printing the crop marks.

To cancel output, tap Cancel. Increase the size of the data, and then send the data again.