Changing the Settings of Registered Media

Follow the procedure below to change the media settings of registered media. These settings can only be changed for the media being set up.

You can also perform the procedure under Changing Media Settings in a Batch.

Procedure
  1. Set up the media whose settings you will change.
  2. Tap Panel_Icon_Menu.
  3. Media Settings - List of Media Settings
  4. Tap the setting to change to move to the screen for editing this setting.
    The media settings that can be changed are as follows.
    Menu itemReference page
    Print Head HeightChanging the Print Head Height
    Feed CorrectionManual Adjustment: Reducing Horizontal Bands (Feed Correction)
    Media Gap AdjustmentManual Adjustment: Adjusting the Misalignment of the Ink Landing Position (Media Gap Adjustment)
    Blade AdjustmentFine-tuning the Cutting Conditions
    Print & Cut Position AdjustmentCorrecting the Misalignment of Printing and Cutting
    Crop Cut Position AdjustmentCorrecting the Misalignment of Printing and Cutting with Crop Marks (Concurrent Test for Printing and Cutting with Crop Marks) Correcting the Misalignment of Printing and Cutting with Crop Marks (Separate Test for Printing and Cutting with Crop Marks)
    Over CutCutting to Make It Possible to Cut Corners Attractively (Over Cut)
    Heater TemperatureSetting the Front Heater Temperature
    Multi Sensor AdjustmentCorrecting the Reading Sensor
    Media Suction ForceUsing Media That Wrinkles Easily/Does Not Move Smoothly
    Printing Movement RangeReducing the Output Time for Narrow Media
    Middle Pinch Auto Raise/LowerUse Middle Pinch Rollers When Pulling Back or Feeding Media
    Media Sticking PreventionUsing Sticky Media
  5. If you have changed a setting, tap Save.
  6. Tap Panel_Icon_Home.
    You are returned to the home screen.