Jump to main content
User’s Manual
Basic Handling Methods
Output Method
Optimizing Quality and Efficiency
Maintenance
Troubleshooting Methods
Appendix
INDEX
Search
Home
Troubleshooting Methods
Cutting Problems
Uncut Areas Remain or Cut Edges Are Not Clean
Is a thick material being used?
Basic Handling Methods
Output Method
Optimizing Quality and Efficiency
Maintenance
Troubleshooting Methods
Cutting Problems
Printing and Cutting Are Misaligned
Uncut Areas Remain or Cut Edges Are Not Clean
Are the blade and blade holder securely installed?
Is the tip of the blade broken?
Is there any buildup of dust or material adhesive on the tip of the blade?
Is there any buildup of pieces of material or dust inside the blade holder?
Is a thick material being used?
Are the blade force and cutting speed appropriate?
Is the blade tip offset appropriate?
Is the machine set to feed forward some amount of material before cutting?
Is "SMOOTHING" set to "OFF"?
Is the blade protector damaged or deformed?
The Machine Cuts the Carrier Paper
The Machine Cuts the Same Area Twice
Crop Marks Are Not Detected
The Material Slips Away from the Pinch Rollers during Cutting
Machine Problems
Software Problems
Data Troubles
Messages on the Operation Panel
Appendix
Is a thick material being used?
When using thick material, set
"QUALITY"
to
"HEAVY"
.
RELATED LINKS
Setting the Cutting Speed
Basic Handling Methods
Output Method
Optimizing Quality and Efficiency
Maintenance
Troubleshooting Methods
Cutting Problems
Printing and Cutting Are Misaligned
Uncut Areas Remain or Cut Edges Are Not Clean
Are the blade and blade holder securely installed?
Is the tip of the blade broken?
Is there any buildup of dust or material adhesive on the tip of the blade?
Is there any buildup of pieces of material or dust inside the blade holder?
Is a thick material being used?
Are the blade force and cutting speed appropriate?
Is the blade tip offset appropriate?
Is the machine set to feed forward some amount of material before cutting?
Is "SMOOTHING" set to "OFF"?
Is the blade protector damaged or deformed?
The Machine Cuts the Carrier Paper
The Machine Cuts the Same Area Twice
Crop Marks Are Not Detected
The Material Slips Away from the Pinch Rollers during Cutting
Machine Problems
Software Problems
Data Troubles
Messages on the Operation Panel
Appendix
Feedback
Was this information helpful?
1
2
3
4
5
NO
YES
Any additional feedback to help us improve.
Feedback
Thank you
