Jump to main content
User’s Manual
Basic Handling Methods
Output Method
Optimizing Quality and Efficiency
Maintenance
Troubleshooting Methods
Appendix
INDEX
Search
Home
Troubleshooting Methods
Cutting Problems
The Material Slips Away from the Pinch Rollers during Cutting
Basic Handling Methods
Output Method
Optimizing Quality and Efficiency
Maintenance
Troubleshooting Methods
Cutting Problems
Printing and Cutting Are Misaligned
Uncut Areas Remain or Cut Edges Are Not Clean
The Machine Cuts the Carrier Paper
The Machine Cuts the Same Area Twice
Crop Marks Are Not Detected
The Material Slips Away from the Pinch Rollers during Cutting
Is the loading lever lowered?
Is the material loaded in parallel with the guide lines?
Is the material making contact with some obstacle during cutting?
Has cutting been performed without checking the material feed? (roll material)
Are the pinch rollers used to secure both edges of the material?
Machine Problems
Software Problems
Data Troubles
Messages on the Operation Panel
Appendix
The Material Slips Away from the Pinch Rollers during Cutting
Is the loading lever lowered?
Is the material loaded in parallel with the guide lines?
Is the material making contact with some obstacle during cutting?
Has cutting been performed without checking the material feed? (roll material)
Are the pinch rollers used to secure both edges of the material?
Basic Handling Methods
Output Method
Optimizing Quality and Efficiency
Maintenance
Troubleshooting Methods
Cutting Problems
Printing and Cutting Are Misaligned
Uncut Areas Remain or Cut Edges Are Not Clean
The Machine Cuts the Carrier Paper
The Machine Cuts the Same Area Twice
Crop Marks Are Not Detected
The Material Slips Away from the Pinch Rollers during Cutting
Is the loading lever lowered?
Is the material loaded in parallel with the guide lines?
Is the material making contact with some obstacle during cutting?
Has cutting been performed without checking the material feed? (roll material)
Are the pinch rollers used to secure both edges of the material?
Machine Problems
Software Problems
Data Troubles
Messages on the Operation Panel
Appendix
Feedback
Was this information helpful?
1
2
3
4
5
NO
YES
Any additional feedback to help us improve.
Feedback
Thank you
