Jump to main content
User’s Manual
Basic Handling Methods
Output Method
Optimizing Quality and Efficiency
Maintenance
Troubleshooting Methods
Appendix
INDEX
Search
Home
Troubleshooting Methods
Cutting Problems
Printing and Cutting Are Misaligned
Basic Handling Methods
Output Method
Optimizing Quality and Efficiency
Maintenance
Troubleshooting Methods
Cutting Problems
Printing and Cutting Are Misaligned
Is a thick material being used?
Is the machine set to feed forward some amount of material before cutting?
Uncut Areas Remain or Cut Edges Are Not Clean
The Machine Cuts the Carrier Paper
The Machine Cuts the Same Area Twice
Crop Marks Are Not Detected
The Material Slips Away from the Pinch Rollers during Cutting
Machine Problems
Software Problems
Data Troubles
Messages on the Operation Panel
Appendix
Printing and Cutting Are Misaligned
Is a thick material being used?
Is the machine set to feed forward some amount of material before cutting?
RELATED LINKS
Adjusting the Cutting Position
Adjusting the Printing Position
Basic Handling Methods
Output Method
Optimizing Quality and Efficiency
Maintenance
Troubleshooting Methods
Cutting Problems
Printing and Cutting Are Misaligned
Is a thick material being used?
Is the machine set to feed forward some amount of material before cutting?
Uncut Areas Remain or Cut Edges Are Not Clean
The Machine Cuts the Carrier Paper
The Machine Cuts the Same Area Twice
Crop Marks Are Not Detected
The Material Slips Away from the Pinch Rollers during Cutting
Machine Problems
Software Problems
Data Troubles
Messages on the Operation Panel
Appendix
Feedback
Was this information helpful?
1
2
3
4
5
NO
YES
Any additional feedback to help us improve.
Feedback
Thank you