103D-0000Milling data error. The milling bur cannot reach the milling position.

Situation/Error Cause
If the milling bur is too short, or if the angle of the A axis and B axis are too large, the milling bur may not reach the milling position in the Z direction.
Procedure
  1. Hold down the touch sensor on the built-in panel.
    This will clear the error.
  2. Review the milling bur length and the position of the milling bur holder.
    Setting the Milling Bur
  3. Review the CAM settings and decrease the angles of the A axis and the B axis.