105F-****The pressure of the compressed air for blowing away the milling waste is out of range.

Situation/Error Cause
The air pressure in the milling area may not be appropriate.
Procedure
  1. Review the regulator settings.
    Adjusting the Pressure of the Compressed Air
  2. Clear the error or resume milling.

    • If the error occurred during milling

      • Press the touch sensor on the built-in panel.
      • Milling resumes.

    • If the error occurred while the machine was on standby

      • Hold down the touch sensor on the built-in panel.
      • This will clear the error.
If the Error Occurs Again
Contact your authorized Roland DG Corporation dealer.