1. Install the detection pin.

Procedure
  1. Open the front cover.

    Pull until a click is heard.

    DWX-53DC_AdapterAreaCover_Open
  2. Remove any debris that is present around the clamp.
  3. Use the included cloth for care to wipe the clamp () and the area around the milling bur sensor () clean.
    If any dirt is present in these locations, it may not be possible to perform the correction properly.
    IMPORTANT Also wipe the bottom of the clamp () clean.
    DWX-53DC_AutoCorrection_01
  4. Wipe the detection pin () and the top () and bottom () of the automatic correction jig clean.

    Clean the gray parts in the following figure. If any dirt is present in these locations, it may not be possible to perform the correction properly.

    IMPORTANT Also wipe the bottom and the shaft of the automatic correction jig clean.
    DWX-53DC_AutoCorrection_02
  5. Load the detection pin in the ATC magazine's number 15 position.
    MEMO

    Insert the detection pin firmly into the ATC magazine.

    If the pin is loaded in the wrong position or is tilted, an error or malfunction may occur, which could damage the machine.

    DWX-53DC_AutoCorrection_03