4. Remove the detection pin and the automatic correction jig.

Once correction is complete, remove the detection pin and the automatic correction jig, clean them, and then store them.
CAUTION

Do not pull the adapter with excessive force when removing it.

Doing so may result in injury arising from your hand or arm hitting something.

Procedure
  1. Open the front cover.

    Pull until a click is heard.

    DWX-53DC_AdapterAreaCover_Open
  2. Remove the detection pin.
    DWX-53DC_DetectorPin_Remove
  3. Remove the automatic correction jig.
    1. Open the fixing knobs (in two locations) in the directions of the arrows to release the locks.
      DWX-53D_clamp_open
    2. Pull the automatic correction jig out slowly.

      Pull the jig out slowly. Exercise caution to avoid striking the inside of the machine with your hands or other body parts when pulling out this part.

      DWX-53DC_Adapter_Eject
  4. Store the automatic correction jig and detection pin.

    Set the automatic correction jig in the adapter rack, and store the detection pin in the bottom storage.

    DWX-53DC_AutoCorrectionJIG_PIN_Cleaning