Use this section to mount the workpiece on the adapter, and then secure the workpiece by tightening the adapter cap. You can mount workpieces on any adapters. Each adapter has a unique ID label, but the CAM software is used to specify the ID of the adapter used in milling.
Required items
Adapter
Pin-type workpiece
Pin-type workpiece adapter
Torque screwdriver (0.6 N·m)
IMPORTANT
Do not loosen screws with a torque screwdriver with the sleeve () attached.
Doing so may damage the sleeve. Before loosening screws, remove the sleeve from the torque screwdriver.
IMPORTANT
Before tightening a screw that has a specified tightening torque, be sure to attach a sleeve. Check the marking on the sleeve () and use a sleeve that matches the tightening torque value.
Failure to attach a sleeve will cause a torque in excess of the permitted amount to be applied, which may damage parts and materials.
