Retightening the Collet

Continuous milling will cause the collet to become loose, making it easy for the milling bur to come off. Periodically retighten the collet.

Recommended Interval for This Work

  • Once a month, or when the total work time of the spindle exceeds 200 hours (with slight variation depending on the work situation).
Table 1. Required items

DWX-53DC_TorkDriver_ForTable


DWX-53DC_collet_wrench_ForTable

Torque screwdriver (0.3 N·m) Collet attaching/detaching jig
Procedure
  1. Open the Machine settings window.
    1. In the top window of VPanel, select the machine to operate.
      When you have connected multiple machines, you can switch to a different machine to operate by clicking its image under MACHINE STATUS.
    2. Click Icon_VPanel_MachineSetting.

      The Machine settings window is displayed.

      VPanel_Main_MachineSetting
  2. On the Maintenance tab, click Collet maintenance.
    VPanel_MachineSetting_Maintenance_ColletMaintenance
  3. When the window in the following figure is displayed, click OK.

    The spindle unit will move to the milling area.

    VPanel_Dialog_OpenCollet
  4. Open the milling area cover.
    DWX-53DC_MillingAreaCover_Open
  5. Remove the dust-proof cover.
    DWX-53DC_dust-proof_cover_open
  6. Remove the bit from the torque screwdriver and attach the collet attaching/detaching jig to it.
    IMPORTANT

    Be sure to use the 0.3 N·m torque screwdriver sleeve. Failing to do so may lead to a loose collet during milling, which will affect the milling quality and damage the collet.

    TorqueDriver_Sleeve_03Nm
    DWX-53DC_Collet_Tighten_01
  7. Use the torque screwdriver to retighten the collet.

    Align the collet with the groove in the collet attaching/detaching jig. Tighten the screws until turning the handle of the torque screwdriver no longer turns the screw bit.

    DWX-53DC_ColletRetighting_1
  8. Attach the dust-proof cover to the milling area.
    MEMO

    Attach the dust-proof cover so the handle is in the upper-right corner. Check that the magnets on the edge of the cover attach to the mounting frame.

    DWX-53DC_dust-proof_cover_close
  9. Close the milling area cover.

    The retightening of the collet is complete when the spindle unit moves to its original position and The operation is complete. is displayed.