Editing Job Report Templates

To edit a template, you have to open the template file in an editor such as Microsoft Word (or OpenOffice Writer).
MEMO

The images used here are only placeholders and are replaced according to the report settings.

Variables, their data references, and examples that may have to be used are listed below.
Variable syntax (for discs) Data source Alternate syntax (where applicable) Remarks
@99@ DGSHAPE CAM job name
@319@ Milling machine name
@1006@ Printing date of report
@1016@ Estimated total time required for milling by milling machine This value is added to the report after calculation is finished.
@1303@ Thickness of in-use stock
@1300@/xx@ Job dental prosthesis number (record number) To display the imported dental prostheses in a list, you have to change the xx on each row with numbers in ascending order. This variable references the record number corresponding to the report image. See the above example.
@1301@/xx@ .STL/dental prosthesis file name To display the imported dental prostheses in a list, you have to change the xx on each row with numbers in ascending order. This variable references the record number corresponding to the report image. See the above example.
@1304@/xx@ Client name To display the imported dental prostheses in a list, you have to change the xx on each row with numbers in ascending order. This variable references the record number corresponding to the report image. See the above example.
@1305@/xx@ Unit count/element count To display the imported dental prostheses in a list, you have to change the xx on each row with numbers in ascending order. This variable references the record number corresponding to the report image. See the above example.
@1306@ Blank/stock name @1306@/x @ The added "/x@" is optional. This variable is used to indicate at what position on the milling machine the corresponding pin/block is attached.
@1309@ Material lot code @1309@/x @ The added "/x@" is optional. This variable is used to indicate at what position on the milling machine the corresponding pin/block is attached.
@1307@ Magnification/expansion factor or shrinkage factor @1307@/x @ The added "/x@" is optional. This variable is used to indicate at what position on the milling machine the corresponding pin/block is attached.
@1303@ Blank/stock thickness measured along the Z axis @1303@/x @ The added "/x@" is optional. This variable is used to indicate at what position on the milling machine the corresponding pin/block is attached.
@1310@ Cutting strategy name/version
@1318@ Dental prosthesis type @1318@/x@ The added "/x@" is optional. This variable is used to indicate at what position on the milling machine the corresponding pin/block is attached.
@1319@ .BLK name @1319@/x@ The added "/x@" is optional. This variable is used to indicate at what position on the milling machine the corresponding pre-milled blank is attached.
Slot of first cutting bur to use @135@/x@ The added "/x@" is optional. This variable is used to indicate at what position on the milling machine the corresponding pre-milled blank is attached.
Name of first cutting bur to use @311@/x@ The added "/x@" is optional. This variable is used to indicate at what position on the milling machine the corresponding pre-milled blank is attached.
Estimated cutting time @1004@/x@ The added "/x@" is optional. This variable is used to indicate at what position on the milling machine the corresponding pre-milled blank is attached.
@1320@ Total length of toolpath (in meters)/separated according to dental prosthesis @1017@/XX@ To display the imported dental prostheses in a list, you have to change the xx on each row with numbers in ascending order. This variable references the record number corresponding to the report image. See the above example.
Name of replaced interface @1317@/xx@ To display the imported dental prostheses in a list, you have to change the xx on each row with numbers in ascending order. This variable references the record number corresponding to the report image. See the above example.