Step 2: Placing the Object

Procedure
  1. Open the front cover.
    BD-8_UpperCoverOpen
  2. Place the object in the middle of the flat table.
    In consideration of printing misalignment, we recommend that you place a protective sheet below the object.Cleaning the Machine
    MEMO
    To prevent printing misalignment, note the following points.
    • Place the part on which to print in the middle of the flat table.
    • Place the object so it is not tilted in relation to the print data.

    Printing Position Using Alignment Markers Is Misaligned

    Position_OKNotOK
    1. Place the object.
      You cannot use the included adhesive sheet because it hides the alignment markers. Cut before use, or fix the object so that it will not shift.
    2. If necessary, perform the following operations.
      • Use a static removal brush or anti-static cloth to eliminate static electricity from the object.
      • Degrease the printing area of the object using anhydrous ethanol or isopropyl alcohol.
  3. Close the front cover.