Cleaning the Machine

Wipe away any buildup of dust, dirt, or any ink or grime that has adhered to the interior of the machine as part of daily cleaning.
WARNING

Never use gasoline, thinner, or any other flammable material.

Doing so may cause a fire.

MEMO
  • This machine is a precision device and is sensitive to dust and dirt. Perform cleaning on a daily basis.
  • Never attempt to oil or lubricate the machine.
  • Before performing this operation, remove any objects to be printed on.
Procedure
  1. Open the front cover.
    Remove any objects or jigs that are on the flat table.
  2. Clean the locations shown in the following figure.
    BD-8_CleanTheMachine
    A Irradiation surfaces of the UV-LED device Clean by wiping with a cloth moistened by anhydrous ethanol or isopropyl alcohol.Cleaning the UV-LED devices
    Print-head carriage surface Clean by wiping with a cloth moistened by neutral detergent diluted with water then wrung dry or a soft, dry cloth.
    B Vicinity of the flat table
    • Clean by wiping with a cloth moistened by neutral detergent diluted with water then wrung dry or a soft, dry cloth.
    • You can remove ink that has adhered to the flat table by affixing tape to the ink and peeling the tape off.
    C Vicinity of the deodorizer Clean by wiping with a cloth moistened by neutral detergent diluted with water then wrung dry or a soft, dry cloth.
    MEMO If dust and dirt accumulate in the machine, they are likely to affix to the object.
  3. When you have finished cleaning, close the front cover.