Changing the Media Settings

Use the following procedure to change the media settings. These settings can only be changed for the media being set up.
Procedure
  1. Set up the media.
  2. Tap Panel_Icon_Menu.
  3. Tap Media Settings - List of Media Settings.
  4. Tap the setting to change to move to the screen for editing this setting.
    The media settings that can be changed are as follows.
    Menu item Reference page
    Print Head Height Changing the Print Head Height
    Feed Correction Manual Adjustment: Reducing Horizontal Bands (Feed Correction)
    Media Gap Adjustment Manual Adjustment: Adjusting the Misalignment of the Ink Landing Position (Media Gap Adjustment)
    Blade Adjustment Fine-tuning the Cutting Conditions
    Print & Cut Position Adjustment Correcting the Misalignment of Printing and Cutting
    Crop Cut Position Adjustment

    Correcting the Misalignment of Printing and Cutting with Crop Marks (Concurrent Test for Printing and Cutting with Crop Marks)

    Correcting the Misalignment of Printing and Cutting with Crop Marks (Separate Test for Printing/Cutting with Crop Marks)
    Cutting Distance Correction Performing Distance Correction during Cutting
    Over Cut Cutting to Make It Possible to Cut Corners Attractively (Over Cut)
    Heater Temperature Setting the Print Heater TemperatureSetting the Dryer Temperature
    Pullback After Printing Using Heat-resistant Media with Minimal Waste
    Multi Sensor Adjustment Adjusts the sensor used to make corrections to the optimal condition.
    Drying Time Per Scan Sets the drying time per scan operation of the print-head carriage.
    Media Suction Force Using Media That Wrinkles Easily/Does Not Move Smoothly
    Media Sticking Prevention Using Sticky Media
    Middle Pinch Auto Raise/Lower Use Middle Pinch Rollers When Pulling Back or Feeding Media
  5. If you have changed a setting, tap Save.
  6. Tap Panel_Icon_Home.
    The home screen appears.