| Print Head Height |
Changing the Print Head Height |
| Feed Correction |
Manual Adjustment: Reducing Horizontal Bands (Feed Correction) |
| Media Gap Adjustment |
Manual Adjustment: Adjusting the Misalignment of the Ink Landing Position (Media Gap Adjustment) |
| Blade Adjustment |
Fine-tuning the Cutting Conditions |
| Print & Cut Position Adjustment |
Correcting the Misalignment of Printing and Cutting |
| Crop Cut Position Adjustment |
Correcting the Misalignment of Printing and Cutting with Crop Marks (Concurrent Test for Printing and Cutting with Crop Marks)
Correcting the Misalignment of Printing and Cutting with Crop Marks (Separate Test for Printing/Cutting with Crop Marks)
|
| Cutting Distance Correction |
Performing Distance Correction during Cutting |
| Over Cut |
Cutting to Make It Possible to Cut Corners Attractively (Over Cut) |
| Heater Temperature |
Setting the Print Heater TemperatureSetting the Dryer Temperature |
| Pullback After Printing |
Using Heat-resistant Media with Minimal Waste |
| Multi Sensor Adjustment |
Adjusts the sensor used to make corrections to the optimal condition. |
| Drying Time Per Scan |
Sets the drying time per scan operation of the print-head carriage. |
| Media Suction Force |
Using Media That Wrinkles Easily/Does Not Move Smoothly |
| Media Sticking Prevention |
Using Sticky Media |
| Middle Pinch Auto Raise/Lower |
Use Middle Pinch Rollers When Pulling Back or Feeding Media |
.
.
The home screen appears.