5. Install the dancer roller.

Procedure
  1. Raise the dancer roller and place it on the stand legs.
    MEMO The dancer roller has no particular front and rear orientation.

    AG-640_install_dancer-roller-1

  2. On the right side of the dancer roller, bring the flat surface of the shaft (A) toward you, and then temporarily tighten the bolt.

    AG-640_install_dancer-roller-2

  3. On the left side of the dancer roller, temporarily tighten the bolt.
    MEMO Both sides of the shaft are flat on the left side of the dancer roller.

    AG-640_install_dancer-roller-3

  4. Fully tighten the bolt on the right side (A), followed by the left side (B) of the dancer roller.

    AG-640_install_dancer-roller-4