Step 10: Configuring the Settings to Dry the Trailing Edge of the Printing Area
Procedure
-
Tap
to turn the setting on or off.
Drying Feed This setting applies to output data designed only for printing. The margin between the print-end position and the next print-start position is set to a value of 130 mm (5.12 in.) when Extended Dryer is set to Disable and 310 mm (12.2 in.) when it is set to Enable. (On)
Media feed is performed until the trailing edge of the printing area is positioned on the dryer. (Off)
Media feed stops when printing ends. This means that the trailing edge of the printing area is not fed to the dryer unless you continue with a subsequent printing operation. -
Tap
or
to set the Drying Feed drying time.
MEMODrying Time- The next operation is not started until the set time elapses.
- Tap Skip during drying to finish the drying time and start the next operation.
- When the drying time has been set in the software RIP, priority is given to the software RIP's setting.
- If Drying Time is set to a value other than 0 min and Drying Feed is off, the machine waits for the set time at the print-end position before starting the next operation.
-
Tap Save and Proceed to confirm your entry.
MEMODefault setting:
- Drying Feed: Off
- Drying Time: 0 min.