Changing the Media Settings

Use the following procedure to change the media settings. These settings can only be changed for the media being set up.

Procedure
  1. Set up the media.
  2. Tap Panel_Icon_Menu.
  3. Media Settings - List of Media Settings
  4. Tap the setting to change to move to the screen for editing this setting.
    The media settings that can be changed are as follows.
    Menu item Reference page
    Print Head Height Changing the Print Head Height
    Feed Correction Manual Adjustment: Reducing Horizontal Bands (Feed Correction)
    Media Gap Adjustment Manual Adjustment: Adjusting the Misalignment of the Ink Landing Position (Media Gap Adjustment)
    Blade Adjustment Fine-tuning the Cutting Conditions
    Print & Cut Position Adjustment Correcting the Misalignment of Printing and Cutting
    Crop Cut Position Adjustment Correcting the Misalignment of Printing and Cutting with Crop Marks (Concurrent Test for Printing and Cutting with Crop Marks)Correcting the Misalignment of Printing and Cutting with Crop Marks (Separate Test for Printing and Cutting with Crop Marks)
    Cutting Distance Correction Performing Distance Correction during Cutting
    Over Cut Cutting to Make It Possible to Cut Corners Attractively (Over Cut)
    Heater Temperature Setting the Print Heater TemperatureSetting the Dryer Temperature
    Dry After Printing Drying the Trailing Edge of the Printing Area on the Dryer
    Multi Sensor Adjustment Correcting the Reading Sensor
    Drying Time Per Scan Using Hard-to-Dry Media
    Media Suction Force Using Media That Wrinkles Easily/Does Not Move Smoothly
    Printing Movement Range Speeding Up Output for Narrow Media
    Media Sticking Prevention Using Sticky Media
    Middle Pinch Auto Raise/Lower Use Middle Pinch Rollers When Pulling Back or Feeding Media
  5. If you have changed a setting, tap Save.
  6. Tap Panel_Icon_Home to return to the home screen.