Setting the Dryer Temperature

Setting the temperature of the dryer appropriately makes the ink dry fast. An applicable application is changing the set temperature of registered media.

  • With the default settings, the temperature rises to the Standby Heater Temperature when the power turns on. On completion of media setup, the temperature rises to the set value.

  • Depending on the usage environment, the temperature of the dryer may become higher than the set temperature, but this does not represent a problem.

  • Temperature settings are not possible when Heater Power accessed from Media Settings - Heater Settings - Heater Temperature is off.

Procedure
  1. Set up the media.
  2. Tap the following location on the home screen.
    Top_03_Panel
    The Heater Temperature window appears.
  3. Check that the Heater Power checkbox is selected.
    HeaterPowerOn_Panel
  4. Tap Panel_Icon_Minus or Panel_Icon_Plus to set the Dryer temperature.
    When ink drying is poor, set the temperature to a higher value. Note, however, that a temperature that is too high may degrade the media or cause it to wrinkle.
  5. Tap Save to confirm your entry.
  6. Tap Panel_Icon_Home to return to the home screen.
    MEMO
    • Default setting: 50°C (122°F)
    • You can also make this setting in the software RIP. When you have made the setting in the software RIP, the software RIP's setting is used.