Fine-tuning the Cutting Conditions

You can accurately set items such as the blade force, movement speed, and blade offset to match the nature of the media and the shape to cut. First, perform a cutting test, and then determine and enter the setting values. After entering the setting values, perform a cutting test again and check the results. Repeat the process of performing a cutting test and making the settings several times to find the optimal setting values.
Procedure
  1. Set up the media.
  2. Tap Panel_Icon_UDLR Move.
  3. Tap Panel_Icon_LeftArrow.
    The cutting carriage moves to the current base point.
  4. Tap Panel_Icon_UpArrow, Panel_Icon_DownArrow, Panel_Icon_LeftArrow, or Panel_Icon_RightArrow to move the cutting carriage to the location where you want to carry out the cutting test.
    You can freely set the location for the cutting test.
  5. Tap Set Base Point Here.
    You are returned to the home screen.
  6. Close the front cover.
  7. Tap Panel_Icon_Cutter Blade Adjustment on the home screen.
  8. Tap Execute next to Cutting Test.
    The test pattern is cut.
  9. Check the results of the cutting test.
    Check that the two shapes are peeled off separately, a blade trace (red line) remains on the backing paper, and the backing paper is not cut.


    Check item Result Setting item Adjustment
    Check the shape. The cut shape is distorted. Cutting Speed Reduce
    Peel off the circle. The square also peels off. Blade Force Increase
    Some uncut areas remain. Cutting Speed Reduce
    Peel off the square. The blade leaves faint traces on the backing paper. Blade Force No change
    The blade trace is indistinct. Increase
    The blade trace is too deep and cuts into the backing paper. Reduce
    Check the shape of the square you have peeled off.


    		The corners are not rounded and do not have "horns." Blade Offset No change


    		The corners are rounded. Increase


    		The corners have "horns." Reduce
  10. Tap Panel_Icon_Minus or Panel_Icon_Plus to change the settings.
    Screen (cutting conditions) Setting details Default settings
    Blade Force Set the force (pressure) of the blade. 50 gf
    Cutting Speed Set the speed of cutting. 30 cm/s
    Blade Offset

    Set the blade offset. Enter the listed offset value for the blade.

    The offset value for the included blade is 0.250 mm (9.8 mil).

    		 0.250 mm (0.010 in.)
    Rise Movement Speed Set the blade's up speed during cutting (the speed at which the blade travels when it moves to the next cutting line after cutting one cutting line). If the media comes loose during no-load feed and the blade damages the surface of the media, reduce the speed. 30 cm/s
  11. Tap Save to confirm your entry.
  12. Tap Panel_Icon_Home to return to the home screen.