Printing while Processing by the RIP

Use the following procedure to configure the settings so that jobs are printed while they are processed by the RIP. The total processing time will be smaller than the sum of the time it takes to process by the RIP and print separately.

MEMO Under certain conditions, RIP while Printing is disabled.
Procedure
  1. Perform the operation shown below according to what is being set.
    • Job
      • Double-click the job to set.
      • Right-click on the job to set, then click Edit Design - Job Settings .
      • With a job selected, click VW7_JobMenu1 on the left side of the job tool area, and then click VW7_CustomizeJob Settings .

      The Job Settings window appears.

    • Queue folder: Click VW7_Customize for the queue folder.

      The Queue Properties appears.

  2. Click VW7_JobManagement Job Management.
  3. Select the RIP while Printing checkbox under RIP and Print.
    MEMO You can enable this setting even if the Edit - Preferences - RIP and Print - Print Options - Configure Advanced Print Settings checkbox on the menu bar is selected, but the operation is disabled and printing is performed after processing by the RIP finishes.

    Mac: Preferences is displayed as Settings.

  4. Click OK.
    • Any changes made in Job Settings will be applied, and you will be returned to the main window.
    • When changes are made in Queue Properties:
      • When a message for saving the printing settings appears, click OK.

      • To apply the changes to a job already in the queue folder, right-click on the job and click Copy/Paste Setting Value - Apply Current Queue Settings. The changes are reflected in the layout area of the main window.

  5. Perform printing.
    Processing by the RIP and printing are performed at the same time.