Configuring the Queue Folder
This is used to make settings (dedicated settings such as specific media or request details) common to all print data added to the queue folder. In cases such as when the media used or printing specifications are the same, configuring the queue property settings will eliminate the need to configure the job settings for each piece of print data.
Configure the settings of the queue folder in the Queue Properties window.
- The settings are applied to all print data that is added to each queue folder.
- This section explains how to configure the minimum settings required for printing (the size and type of the media to use in printing and the printing quality). Configure other settings according to the application.
MEMO If you are unfamiliar with VersaWorks operation or are not prepared to configure dedicated settings, you do not have to configure the Queue Properties settings. You can change the settings for each print data entry to print with the same settings as if you had configured the Queue Properties settings.
Procedure
-
Click
for the queue folder to be used.
The Queue Properties window appears. -
To set the size of the material, click
and perform the following procedure.
- Manual setup
- Select the desired size from OK. , and then click
- If you want to specify a size, select CustomROLL or CustomCUT, and then set W or W and H.
- Automatic Setup
- Set up the media.
- Click
Obtain the W or W and H for the media that has been set up, and then configure the settings.
.
- Manual setup
-
Click
.
- Select the type of the media to print on from the Media Type list.
-
Use Print Quality to select the printing quality.
-
Click OK .
The print settings you have set are saved. You can also configure many other settings for the queue folder.