Step 1: Print with crop marks.
Procedure
-
Perform the operation shown below according to what is being set.
- Job: Double-click the job to open the Job Settings window.
- Queue folder: Click
for the queue folder to open the Queue Properties window.
-
Click
.
- Select the Crop Marks (Print&Cut Alignment) check box.
-
Click
.
- From the Operation Mode list, select Print Only.
-
Click OK.
- Any changes made in Job Settings will be applied.
- When changes are made in Queue Properties:
- A message that printing settings will be overwritten appears. Click Yes.
-
To apply the changes to a job already in the queue folder, select the job and click
.
MEMO- The print data is an EPS file.
- A cutting line has been drawn around the border.
If both of the above conditions are met, additional settings are required. If you do not configure these additional settings, it may not be possible to cut a part of the border. Configure the settings shown below.
- In the Queue Properties window, click
.
- Enter a value in Margin under EPS.
- If you scale the image in the or window, the size of the margin will also be scaled.
- When you add a job to the job list, the margin set with Margin is automatically added within the range specified by the border.
-
Add the job containing cutting lines to the job list, and then click
.
MEMO These settings can also be customized per job using the Job Settings window.The job is printed with crop marks.
