Step 2: Setting the Heater Temperature

The print heater and dryer temperatures can be set as needed.

Setting the temperature of the print heater appropriately improves ink adhesion and inhibits smudging.

Setting the temperature of the dryer appropriately also makes the ink dry fast.

  • With the default settings, the temperature rises to the Standby Heater Temperature when the power turns on. On completion of media setup, the temperature rises to the set value.

  • Depending on the usage environment, the temperature of the dryer may become higher than the set temperature, but this does not represent a problem.

Procedure
  1. Check that the Heater Power is turned on.
    HeaterPowerOn_Panel
  2. Tap Panel_Icon_Minus or Panel_Icon_Plus to set the Print Heater or Dryer temperature.
    Print Heater: If the ink forms lumps or smudges, raise the temperature. Note, however, that a temperature that is too high may degrade the media or cause it to wrinkle.
    Dryer: When ink drying is poor, set the temperature to a higher value. Note, however, that a temperature that is too high may degrade the media or cause it to wrinkle.
  3. Tap Save and Proceed.
    MEMO
    • Default setting:
      • Print Heater: 40°C (104°F)
      • Dryer: 50°C (122°F)

    • Depending on the RIP software you are using, you can also configure this setting in the RIP software. If you have configured the setting in the RIP software, the RIP software setting is used.