Changing the Media Settings

Use the following procedure to change the media settings. These settings can only be changed for the media being set up.
Procedure
  1. Load the media.
  2. Tap AP-640_Panel_Icon_MENU.
  3. Tap Media Settings - List of Media Settings.
  4. Tap the setting to change to move to the screen for editing this setting.
    The media settings that can be changed are as follows.
    Menu itemReference page
    Print Head HeightChanging the Print Head Height
    Feed CorrectionManual Adjustment: Reducing Horizontal Bands (Feed Correction Function)
    Media Gap AdjustmentManual Adjustment: Adjusting the Misalignment of the Ink Landing Position (Media Gap Adjustment)
    Blade AdjustmentFine-tuning the Cutting Conditions
    Print & Cut Position AdjustmentCorrecting the Misalignment of Printing and Cutting
    Crop Cut Position AdjustmentCorrecting the Misalignment of Printing and Cutting with Crop Marks (Concurrent Test for Printing and Cutting with Crop Marks)Correcting the Misalignment of Printing and Cutting with Crop Marks (Separate Test for Printing/Cutting with Crop Marks)
    Cutting Distance CorrectionPerforming Distance Correction during Cutting
    Over CutCutting to Make It Possible to Cut Corners Attractively (Over Cut)
    Heater TemperatureChanging the Print Heater TemperatureChanging the Dryer Temperature
    Dry After PrintingDrying the Trailing Edge of the Printing Area on the Dryer
    Multi Sensor AdjustmentCorrecting the Reading Sensor
    Drying Time Per ScanUsing Hard-to-Dry Media
    Media Suction ForceUsing Media That Wrinkles Easily/Does Not Move Smoothly
    Printing Movement RangeSpeeding Up Output for Narrow Media
    Media Sticking PreventionUsing Sticky Media
    Middle Pinch Auto Raise/LowerUse Middle Pinch Rollers When Pulling Back or Feeding Media
  5. If you have changed a setting, tap Save.
  6. Tap AP-640_Panel_Icon_HOME to go back to the original screen.