Manual Adjustment: Adjusting the Misalignment of the Ink Landing Position (Media Gap Adjustment)
First, print a test pattern, and then determine and enter the correction value. After entering the correction value, print a test pattern again and check the correction results.
This adjustment must be performed in the following cases.
When using this machine for the first time
When changing the media to use
When you have changed the print-head height
Procedure
- Load the media.
- Close the front cover.
- Tap .
- Tap .
- Select Detailed Correction (Manual) and tap Next.
- Tap Execute next to Printing Test.Printing of the test pattern starts.
- Check the printed test pattern, and then tap or to enter the No. 1: H1 to H4 and No. 2: H1 to H4 correction values.Select the value that gives the least misalignment between the two lines. In the case of the following figure, select "+5" for H1 and H3 and "+4" for H2 and H4. When you cannot choose between two sequential numbers, select a value that is between them (you can set correction values in units of "0.5").MEMO
- If the test pattern is difficult to see, tap or next to Media Feed to move the media to a position where it is easier to see.
- If you want to hold the media to check the test pattern, tap Execute next to Sheet Cutting to separate the media. However, the sheet is cut at the current blade position, so tap to feed the test pattern to the desired cutting position, and then tap Execute. Separating the Media
- Tap Save.The entered correction values are saved.
- Tap Execute next to Printing Test.The test pattern is printed again.
- Check the test pattern to see whether the correction was successful.For all the correction values, check that the misalignment is minimized for the two vertical lines indicated by "" (that is, the current correction value). If the misalignment is smaller for another set of vertical lines, set the correction value again.
- When you have successfully performed the correction, tap to go back to the original screen.