Operation Panel

MG2_Panel-Home
No.NameDetails
Status bar

Displays the printer status and indicates the next operation.

The following is displayed during printing.
  • MG2_PNLicon_Print

    During printing, the number of copies to print is indicated with */*. The left side indicates the number of the copy currently being output. The right side indicates the total number of copies.

  • MG2_PNLicon_Layer

    During printing, the layers are indicated with */*. The left side indicates the layer currently being output. The right side indicates the total number of layers.

  • 00:10

    Displays the remaining output time (approximate).

Media information

Displays the media name and media width (W) for media that has been set up. If the remaining media setting has been configured, the remaining media (L) is also displayed.

Tap the media width (W) or the remaining media (L) to display the Remaining Media Management screen on which you can set the remaining media.

Checking the Remaining Media

When the base point is changed, BasePoint_ICON appears.

Amount of ink remainingDisplays the amount of ink remaining in each ink cartridge. If it is time to replace an ink cartridge, icon_Panel_Error_Caution is displayed next to the corresponding cartridge. Tap this icon to display the detailed information for the ink.
Front heater temperatureThe front heater temperature is displayed as current temperature/set temperature. Tapping one of these items displays a screen for the following settings.
  • When media is set up
    • Heater Temperature setting
  • When no media is set up
    • Standby Heater Temperature setting
Amount of cleaning liquid remainingDisplays the amount of cleaning liquid remaining. When the amount remaining is low, icon_Panel_Error_Caution is displayed. When there is none left, icon_Panel_Error_Empty is displayed. When the cleaning liquid cartridge is pulled out, icon_Panel_Error_Removed is displayed.
Amount of wiper remainingDisplays the amount of wiper remaining. When the amount remaining is low, icon_Panel_Error_Caution is displayed. When there is none left, icon_Panel_Error_Empty is displayed.
Take-up unit

Displays the status of the take-up unit. Tap to display the Take-up screen, where you can set Take-up during Cutting, Take-up Method, and Take-up Direction.

When Take-up during Cutting - Enabled is set, MG2_RollinCut is displayed.

HomeDisplays the home screen.
MenuDisplays various setting menus.
NotificationsDisplays important information. When there are notifications, their number is displayed next to the icon.
Sub powerTurn off the sub power. Tap the operation panel to turn the sub power back on.
Setup/Cancel Setup

Starts/cancels the setting up of the media.

Setup of New Media

Setup of Registered Media

Cleaning/Nozzle Drop-out TestDisplays the menu related to the printing test and cleaning for the nozzle drop-out check.
Blade AdjustmentSets cutting conditions. This is only enabled when media has been set up.

Fine-tuning the Cutting Conditions

Move

The media can be fed and the cutting carriage can be moved. You can also set the position moved to as the right edge of the printing area (the base point).

Adjusting the Output-start Location

Sheet CuttingActivates the separating knife to separate the media. You can also perforate the media to take it up and separate it at a later time. This is only enabled when media has been set up.

Separating the Media