2. Set the lower-right corner of the object to be printed on to the base printing position.

Set the base printing position (home position) at the front right of the print area. This method is appropriate when the print site is level, and you can clearly specify the print area.

Print area setup can be performed with the front cover open. However, if the front cover is left open for approximately 40 seconds, the print heads automatically return to the home position to prevent the print heads from drying out. The menu returns to the previous one. Repeat the procedure.

Procedure
  1. Press [◀].
  2. Press [▼] twice, and then press [▶] once to display the screen shown below.


  3. Press [▲] or [▼] to select "LOWER R".
  4. Press [ENTER] to confirm your entry.
  5. Press [MENU], then [◀] to go back to the original screen.