Cleaning the Tool Area

Procedure
  1. Check that the machine is in the ready status.

    If the status light at the top of the machine or in the milling area is lit in blue, the machine is in standby.

    Statuses Indicated by Status Light Color
  2. Open the front cover.

    Pull until a click is heard.

    DWX-53DC_AdapterAreaCover_Open
  3. Clean the tool area.

    Use the included brush when cleaning. Use the included cloth for care to carefully wipe away the milling waste from the dummy pin stocker (), milling bur stocker (), and around the milling bur sensor ().

    Any milling waste not removed may affect the milling quality.

    DWX-53DC_ToolArea_Maintenance
  4. Close the front cover.

    Gently pull up on the front cover and then lower it until a click is heard.

    DWX-53DC_Cover_Close