Cleaning the Milling Bur/Adapter

Procedure
  1. Use the included cloth for care to wipe off any dirt from the gray portions indicated in the following figures.
    DWX-53DC_Adopter_Tool_Cleaning

    When using a pin-type workpiece adapter, carefully wipe off the securing screw section () and the pin insertion section (). Exercise special care when cleaning the securing screw and the hole in which the pin is inserted because it is easy for milling waste to remain in these areas.

    Any milling waste not removed may prevent the material from being secured correctly, affecting the milling quality.

    PinAdapter_Cleaning
  2. Store the milling bur and the adapter.
    MEMO

    The milling bur in the milling bur holder can be stored in the bottom storage by standing it in the tool rack with it oriented with its circular holes on the top.

    DWX-53DC_ToolStocker_MIllingBur

    You can store unused milling burs in their cases by standing them in the tool rack with it oriented with its square holes on the top. In this situation, the tool rack will not fit in the bottom storage, so place it next to the machine.