1. Attaching the Regulator to the Machine
Procedure
-
Temporarily tighten the two screws (for the regulator) () on the right side of the machine.
Turn the screws approximately 3 times by hand.
-
Mount the regulator bracket () onto the screws temporarily tightened in step 1, and then fully tighten these screws with a torque screwdriver.
IMPORTANT
Attach the 0.6 N·m, red sleeve onto the torque screwdriver before tightening the screws.
-
Attach the drain hose () to the regulator bowl ().
-
Insert the air hose into the machine.
WARNING
Securely insert the air hose as far as it will go. Lightly tug the hose to make sure it does not come loose.
If it is not inserted securely, it may come loose.
Attach the air hose included with the machine.
-
While pressing the regulator ring in, insert the air hoses into the regulator.
WARNING
Securely insert the air hose as far as it will go. Lightly tug the hose to make sure it does not come loose.
If it is not inserted securely, it may come loose.
Attach to the left side of the regulator the air hose () included with the compressor you are using. Attach to the right side of the regulator the opposite side of the air hose () attached to the machine.
-
Supply compressed air and verify that air does not leak from the connections or any other location.
MEMO To remove an air hose from the regulator, pull the hose out slowly while pressing the regulator ring in.