Step 2: Attach the pre-milled block.

Procedure
  1. Attach the pre-milled block to the attachment.

    When attaching, insert the pre-milled block as far as possible so there is no gap.

    DWX-43W_attachment_03
  2. Tighten the mounting screws that were included with the attachment using a torque screwdriver to secure the pre-milled block.

    Tighten the screws until turning the handle of the torque screwdriver no longer turns the screw bit.

    DWX-43W_attachment_04

Before starting attachment milling, check that the milling bur to be used for milling is set and that registration has been completed.

After milling is completed, use a torque screwdriver to remove the mounting screws, then remove the attachment.

IMPORTANT

To remove the attachment, use the handle () and bit () of the torque screwdriver. Do not use a sleeve ().

TorqueDriver_NoSleeve