Step 1: Attach the attachment.

IMPORTANT When the included holder is installed onto the rotary axis unit and the clamp is changed to the multi-pin clamp, remove the holder before performing this work.
Procedure
  1. Open the front cover.

    Hold the parts shown in the figure with both hands and open the cover.

    DWX-43W_main_10
  2. Attach the attachment to hole "2" on the rotary axis.
    MEMO

    Check the following two points when attaching the attachment.

    • No dirt or milling waste is adhering to the installation surface of the attachment.
    • There is no gap when the attachment is pressed against the rotary axis.
    DWX-43W_attachment_01
  3. Secure the attachment by tightening the mounting screw using a torque screwdriver.

    Tighten the screws until turning the handle of the torque screwdriver no longer turns the screw bit.

    DWX-43W_attachment_02