Setting the Milling Bur

WARNING

Securely fasten the milling tool and workpiece in place. After securing in place, make sure no installation tools or other articles have inadvertently been left behind.

Otherwise, such articles may be thrown from the machine with force, posing a risk of injury.

CAUTION

Under no circumstances should you move the Z-axis unit with your hands.

Doing so may cause a breakdown.

Procedure
  1. Open the front cover.

    Hold the parts shown in the figure with both hands and open the cover.

    DWX-43W_main_10
  2. Set the milling burs in the ATC magazine.
    CAUTION

    Be careful around the tip and other sharp edges.

    Be careful not to touch the tool tip or any other sharp edges. Doing so may cause injury.

    MEMO
    • Set milling burs with their tips facing down.
    • Push milling burs in until the top of each milling bur holder is at the same height as the ATC magazine surface.
    • Do not set a milling bur in the stocker for the dummy pin.
    DWX-43W_millingbur_setting
  3. Close the front cover.