Mounting the Workpiece

WARNING

Securely fasten the milling tool and workpiece in place. After securing in place, make sure no installation tools or other articles have inadvertently been left behind.

Otherwise, such articles may be thrown from the machine with force, posing a risk of injury.

CAUTION

Under no circumstances should you move the Z-axis unit with your hands.

Doing so may cause a breakdown.

Procedure
  1. Open the front cover.

    Hold the parts shown in the figure with both hands and open the cover.

    DWX-43W_main_10
  2. Insert the pin portion of the workpiece into the hole on the rotary axis.

    Align the notch on the root of the workpiece's pin with the protrusion on the rotary axis so as to eliminate the gap between the attaching surfaces.

    DWX-43W_work_03
    MEMO

    When the workpiece type is PMMA, the maximum number of workpieces that can be installed is two. However, when installing two workpieces, do so in positions 1 and 3 so that there is space between the workpieces.

    DWX-43W_work_02
  3. Use a mounting screw to secure the workpiece in place.

    Tighten the mounting screw with a hexagonal screwdriver.

    DWX-43W_work_04
  4. Close the front cover.