1. Attaching the Oven
Procedure
- Open the front cover.
-
Remove the screw shown in the figure and remove the tape.
-
Lock the stand casters.
-
Place two bolts in each of the positions indicated with the red arrows in the figure.
Prepare these bolts in advance to allow you to temporarily tighten them with a single hand in the work of steps 6 and 7 without having to change your posture.
-
Grasp the handles (a) and lift the oven, insert it into the holes on the stay (), and then gently lower the oven to the printer side ().
Do not release the handles yet.
-
While supporting the oven with one hand, use your other hand to temporarily tighten the bolt.
-
Attach a (small) shaft clamp, and then temporarily tighten its bolt.
-
Use a hexagonal wrench to fully tighten the bolts from steps 6 and 7 (two bolts on the left side and two on the right side).
Tighten the bolts until they stop turning. When a bolt is tightened appropriately, the gap shown in the figure disappears, and the printer and oven are fitted tightly together.