Step 10: Connecting the Cables

WARNING

Perform this task with all power switches left switched off.

Otherwise sudden movement of the machine may cause injury.

WARNING

Connect to an electrical outlet that complies with this machine's ratings (for voltage, frequency, and current).

Incorrect voltage or insufficient current may cause fire or electrical shock.

WARNING

Handle the power cord, plug, and electrical outlet correctly and with care. Never use any article that is damaged.

Using a damaged article may result in fire or electrical shock.

WARNING

When using an extension cord or power strip, use one that adequately satisfies the machine's ratings (for voltage, frequency, and current).

Use of multiple electrical loads on a single electrical outlet or of a lengthy extension cord may cause fire.

Procedure
Connect the relay power cord, the Ethernet cable (commercially available), and the (two) power cords.

Insert the relay power cord into the printer and stand stay insertion ports, the Ethernet cable into the printer and network insertion ports, and the (two) power cords into the stand stay and 200 to 240 V power supplies.

DA-640_cnnect-cable

The recommended Ethernet and Ethernet cable are as follows.
  • Ethernet: 1000BASE-T
  • Ethernet cable: Category 5 or higher
WARNING

Connect this machine to an electrical outlet. Never connect this machine directly to a power distribution panel or other such fixed wiring equipment.

Doing so increases the risk of fire or electrical shock.

WARNING

Connect to ground.

Failure to ground the machine may result in electrical shock when the machine is touched. Be sure to connect to ground.