Step 8: Removing the Handles and the Retainers

IMPORTANT
  • Make sure to remove all the retainers. Any that remain may cause faulty operation or breakdown when the power is switched on.
  • Attach the handles and retainers in the specified locations because these parts are needed again when transporting the machine.
Procedure
  1. Remove the handle at the top of the oven and attach it to the stand stay.
    1. Remove the bolts securing the handle at the top of the oven.

      DA-640_remove-oven-handle_1

    2. Attach the removed bolts in their original positions.

      DA-640_remove-oven-handle_2

    3. Remove the bolts securing the right cover, and then attach one of these bolts in the position (A) shown in the figure.
      Position (A) is right next to the location where a bolt was attached in step (2).

      DA-640_remove-oven-handle_3

    4. Use the other bolt to attach the handle in the position shown in the figure on the rear of the main unit.

      You can attach two handles to the stand stay (the top and bottom locations shown in the illustration). Attach the handle in one of these locations.


      DA-640_remove-oven-handle_4

    5. Perform the same work for the left handle and the left cover.
  2. Open the front, left, and right covers.
  3. Remove all the retainers and attach them in the prescribed positions.
    1. Remove all the retainers.

      DA-640_retainers-front

    2. Use a removed bolt to attach retainer C in the position shown in the figure.

      DA-640_C-retainer-fixing

    3. Use removed bolts to attach retainer D in the position shown in the figure.

      Rotate retainer D by 180° and install it at the position that hides the gear.


      DA-640_D-retainer-fixing

  4. Close the front, left, and right covers.