1. Attaching the Stays

Procedure
  1. Place the left stay on the left stand as seen from the front of the printer, and then temporarily tighten the bolt shown in the figure.
    DA-640_TU_fixed-stay-1
    MEMO The stays for the left and right are different. Attach the stays so the holes shown with arrows in the following figure face the center (inside) of the printer.

    DA-640_stays_LR

  2. Temporarily tighten the bolts at the bottom of the left stay, followed by the bolts at the top.
    DA-640_TU_fixed-stay-2
  3. Use a hexagonal wrench to fully tighten the bolts temporarily tightened in steps 1 and 2.
    DA-640_TU_fixed-stay-3
    IMPORTANT Hold the pieces together so there is no gap between the left stay and stand when tightening the bolts.
  4. In the same manner, attach the right stay as seen from the front of the printer.