Start-up Cleaning Methods
WARNING
Be sure to perform operations as specified by the instructions, and never touch any area not specified in the instructions.
Sudden movement of the machine may cause injury.
IMPORTANT Important notes on this procedure
- Before attempting this operation, remove any media.
- To prevent the print heads from drying out, finish this procedure in 10 minutes or less.
- Never use any implements other than the included cleaning sheet.
- Do not use cleaning liquid other than the included cleaning liquid.
- Be sure to use a new cleaning sheet. Reusing a cleaning sheet will adversely affect the printing results.
- A warning beep sounds 10 minutes after operation starts. Perform the operation by following the message displayed in the Utility window.
MEMO
-
When the cleaning sheet and cleaning liquid used for start-up cleaning run out, purchase them from your authorized dealer.
-
The print heads are components that wear out. Periodic replacement is required, with the frequency of replacement depending on use. Contact your authorized dealer.
-
Use the following link to view a reference video for this procedure. We recommend that you view this video to understand the overall flow of work.
| Required items | |||
|---|---|---|---|
 |
 |
 |
 |
| Head nozzle refresher | Cleaning sheets | Dropper | S-PG2-CL cleaning liquid |
Procedure
- Remove any media.
-
Click
Cleaning.
-
Click Execute under Start-up cleaning.
MEMO The procedure for performing start-up cleaning appears in the Utility window. Carefully read the on-screen instructions and carry out the work.
-
When cleaning finishes, click Close.
The previous window will be displayed.