Daily Shut-down Cleaning
Perform start-up cleaning before performing daily shut-down cleaning in the following situations.
-
If the printer will not be used for 24 hours or more after performing daily shut-down cleaning
To prevent dot drop-out and dot displacement, perform start-up cleaning before performing daily shut-down cleaning.
-
If the printer is not used for a period longer than one week
Even if you are not using the printer, turn on the sub power once a week and perform start-up cleaning followed by daily shut-down cleaning.
IMPORTANT If the printer is not used for a period longer than one week, the risk of ink hardening increases.MEMO The printer should not go unused for more than a week. To stabilize ink discharge, constantly operate the printer, even if the amount of daily printing has decreased. This constant printer operation leads to improved print quality.
Daily Shut-down Cleaning Methods
Be sure to perform operations as specified by the instructions, and never touch any area not specified in the instructions.
Sudden movement of the machine may cause injury.
Important notes on this procedure
- Before attempting this operation, remove any media.
- To prevent the heads from drying out, finish this procedure in 30 minutes or less. An alarm sounds after 30 minutes.
- Never use any implements other than the included cleaning sticks. Cotton swabs or other lint-producing items may damage the heads.
- Use one cleaning stick per cleaning session, and then discard the stick after use. Reusing cleaning sticks may reduce print quality.
- Do not put a cleaning stick that has been used for cleaning into the cleaning liquid. Doing so will deteriorate the cleaning liquid.
- Never rub the nozzle surface of the heads.
- Stroke the sponges very gently, applying as little pressure as possible. Never rub, scrape, or crush them.
When a warning beep sounds during cleaning
To prevent the print heads from drying out, an alarm sounds about 30 minutes after the start of the operation. Perform the operation by following the message displayed in the Utility window.
Required items | ||
---|---|---|
|
|
|
Cleaning stick | S-PG2-CL cleaning liquid | Dropper |
-
When the cleaning stick and cleaning liquid used for daily shut-down cleaning run out, purchase them from your authorized dealer.
-
The print heads are components that wear out. Periodic replacement is required, with the frequency of replacement depending on use. Contact your authorized dealer.
-
Use the following link to view a reference video for this procedure. We recommend that you view this video to understand the overall flow of work.
- Remove any media.
-
Click
Cleaning.
-
Click Execute under Daily shut down cleaning.
MEMO The procedure for performing daily shut-down cleaning appears in the Utility window. Carefully read the on-screen instructions and carry out the work.
-
When cleaning finishes, click Close.
The display returns to the original window.