Loading Sheet Media

When loading sheet media in the machine, use the right edge of the media as a reference. This is because the range of movement of the right pinch roller is fixed.

Place the media in a position where the following conditions are met and where media waste will be minimized.
  • Position of right edge of media

    Within the right pinch roller movable range and where about 10 mm (0.39 in.) between the right roller edge of the right pinch roller and the right edge of the media can be secured.

  • Position of left edge of media

    Where about 10 mm (0.39 in.) between the left edge of the roller and the left edge of the media can be secured when placing the left pinch roller within the range of the grit pattern.


    Setup_CutMedia

MEMO

Use the following link to view a reference video for this procedure. We recommend that you view this video to understand the overall flow of work.

https://youtu.be/y3pYUMM4tCs
y3pYUMM4tCs
Procedure
  1. Open the front cover.
    FrontCoverOpen
  2. Move the right pinch roller () and the right media clamp () to the right end.

    Press the part indicated by the arrow on the right pinch roller to move the roller and the right media clamp together.

    MoveClampPinch_R
  3. Move the left pinch roller () and the left media clamp () to the left end.

    Press the part indicated by the arrow on the left pinch roller to move the roller and the left media clamp together.

    MoveClampPinch
  4. Use the following procedure to load the media.
    1. Pass the media () under the right media clamp ().
      MEMO

      If the left edge of the media hits the left media clamp, pass the media under the left media clamp.

      MEMO

      Lifting the tip of the media clamp to pass the media through may cause the blade to come into contact with the media. Be careful not to allow contact with the blade.

      CutMedia1
    2. Pass the media () between the right grit roller () and right pinch roller () to the back.

      Feed the media and line up the edge of the media with the edge of the apron ().

      MEMO

      If the left edge of the media is left of the left pinch roller, pass the media between the left grit roller and left pinch roller as well.

      CutMedia2
  5. Straighten the media.
    CutMedia3
  6. Press lightly on the media, and place the left media clamp and left pinch roller on the media.

    Place the left pinch roller () within the grit pattern ().

    Ensure that marginAfrom the left edge of the media to the left edge of the left pinch roller is at least 10 mm (0.4 in.).

    PinchPos
    MEMO

    If at least 10 mm (0.4 in.) cannot be ensured for marginAfrom the left edge of the media to the left edge of the left pinch roller, move the right pinch roller and the media to the left to provide the margin.

    The range of motion of the right pinch roller is fixed. Place the right pinch roller within the movable range in a position that ensures margin A from the right edge of the media to the right edge of the right pinch roller is about 10 mm (0.39 in.).
    MediaSet5
  7. Lower the loading lever.
    LeverDown2
  8. Line up the edges of the media with the centers of the holes of the left media clamp.
    MediaSet6
  9. Close the front cover.
  10. Click OK.
    InitialSettings_Media