Loading Roll Media
Use the following link to view a reference video for this procedure. We recommend that you view this video to understand the overall flow of work.
https://youtu.be/Os_Z7k8-3PE
-
Open the front cover.
-
Move the right pinch roller () and the right media clamp () to the right end.
Press the part indicated by the arrow on the right pinch roller to move the roller and the right media clamp together.
-
Move the left pinch roller () and the left media clamp () to the left end.
Press the part indicated by the arrow on the left pinch roller to move the roller and the left media clamp together.
-
Use the following procedure to load the media.
-
Pull out the media and load it from above the plate in front with the arrow stickers.
-
Pass the media () between the right grit roller () and right pinch roller ().
MEMO
If the left edge of the media is left of the left pinch roller, pass the media between the left grit roller and left pinch roller as well.
-
Pass the media () under the right media clamp (), and pull it out about 20 cm (7.87 in.) from the edge of the apron ().
MEMO
If the left edge of the media hits the left media clamp, pass the media under the left media clamp.
MEMOYou will hear a beep. Approximately 2 seconds later, you will hear two beeps, and then the suction fan will activate. While this fan is operating, the position of the media will be maintained even if you remove your hands from it.
-
Hold the media holder flange and take up about 20 cm (7.87 in.) of media.
MEMODo not take up so much media () that the sensor () becomes visible.
If you take up too much media, you will hear two short beeps and the suction fan will stop. If the media comes off or is not straight, take up the media and redo the procedure from step 4.
-
Pull out the media and load it from above the plate in front with the arrow stickers.
-
Place the left media clamp and the left pinch roller.
Place the left pinch roller () within the grit pattern ().
Ensure that margin A from the left edge of the media to the left edge of the left pinch roller is at least 10 mm (0.4 in.).
-
Lower the loading lever.
-
Line up the edges of the media with the centers of the holes of the left media clamp.
- Close the front cover.
-
Click OK.
