Cautionary note on making output with cutting

Points to Note when Cutting Only

For roll media, let the media hang down to the rear before outputting.

When using the roll media and only performing cutting, let the media hang down to the rear of the machine. This prevents a motor error or fall of the media caused by the media being pulled with excessive force.

Do not cut the media before it is taken back if "Take back after printing" is specified in the BN-20 driver.

Do not cut the media before it is taken back when Rewind Media After Printing is ON in the Printer Adjustment tab of the BN-20 driver.

When Rewind Media After Printing is checked, the media is taken back after printing. If the media is cut before it is taken back, ink might be ejected to a location where there is no media.

In the case of print and cut, dry the ink sufficiently before cutting.

You can set time for the printer to wait before cutting (Dry Time) with the R-Works, BN-20 driver, or VersaWorks. The dry time varies according to the media.