1. Attach arm A.

Procedure
  1. Temporarily tighten the bolts on the left stand as seen from the front of the printer.
    Tighten the bolts in the holes on the side of the stand until you can see approximately 5 mm (0.2 in.) of their threads (A).


  2. Attach arm A (left) to the temporarily tightened bolts, and then slide this arm to the right.


    MEMO There are two different arm A parts: left (A) and right (B). Attach them on the correct sides.


  3. By hand, tighten the temporarily tightened bolts until there is no gap between the left arm and the stand.
    IMPORTANT Hold the pieces together so there is no gap between arm A (left) and stand when tightening the bolts.
  4. Make sure the protrusion on the stand leg (A) is in the center of the hole on arm A (B).
    Move arm A to the left and right until this protrusion is centered.

    AP-640_InstallDryerUnitArm_ProtrusioninHole

  5. Temporarily tighten the bolts at the bottom of arm A (left).


  6. Use a hexagonal wrench to fully tighten the upper bolts followed by the lower bolts .


  7. In the same manner, attach arm A (right) to the right side as seen from the front of the printer.